Raychem QuickStat Installation Manual download pdf (Page 2)

QuickNet-RK Installation Instructions

3 4

• Turn off the power to the QuickNet floor warming system at the

circuit breaker before starting any repair work.

• If the damaged section has not been installed in mortar, proceed

to Step 7.

• Remove the tile above the damaged section by removing the

grout with a removal tool, being careful not to further damage

the heating cable. Do not use a knife or chisel.

• Once the grout is removed, carefully break away the tile using a

hammer.

• Remove any broken tile and vacuum other debris from the

exposed surface to locate the damaged heating cable section.

• To expose the damaged section, break mortar away from the

heating cable with the hammer, making sure not to damage the

cable.

OFF

Damage

location

Heating

cable

• Disconnect the QuickNet cold leads, power wires and floor sensor

leads from the the QuickStat Thermostat. This provides additional

safety and allows for the testing required in later steps.

L1 (L)

L2 (N)

240/(120)VAC

16A

Max.

QuickStat

GFCI Class A

LINE

LOAD

SENSOR

Line

(black)

Back of thermostat

Neutral

(white)

Cold

lead

Cold

lead

Cold leads

Ground

Power

Floor sensor leads

L1 (L)

L2 (N)

240/(120)VAC

16A

Max.

QuickStat

GFCI Class A

LINE

LOAD

CAUTI

Vol

tag

e -

Dis

nnec

pow

ly be

fore

icin

UAL

VOL

AGE

/60

40W

240VA

C (

16A)

1920

0VA

(

)

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Raychem QuickStat Installation Manual Page 2

Comments to this Manuals

Related products and manuals for Thermostats Raychem QuickStat